TRICONEX 3511是英维思Triconex系统中的通信模块

TRICONEX 3511是工控DCS（分布式控制系统）模块，用于工业自动化和过程控制中的数据处理和控制功能

  公司主营进口PLC模块，可编程控制器，伺服控制系统，和DCS备件等，例如：ABB、AB、GE， Bently，FOXBORO. MOTOROLA. XYCOM. HONEYWELL. TRICONEX. SCHNEIDER. REXROTH. YOKOGAWA .KUKA .OVATION .HIMA.等。英维思卡件 TRICONEX 3511 Invensys控制系统 通讯模块 可提供产品报价、资料 细节请与我联系输出回路设计注意事项：3.1、输出方式选择

(1)继电器输出：优点是不同公共点之间可带不同的交直流负载，且电压也可不同，带负载电流可达2A 点；但继电器输出方式不适用于高频动作的负载，这是由继电器的寿命决定的 (2)晶闸管输出：带负载能力为0.2A/ 点，只能带交流负载，可适应高频动作，响应时间为 1ms (3)晶体管输出：优点是适应于高频动作，响应时间短，一般为0.2ms左右，但它只能带DC5-30V的负载，输出负载电流为0.5A/点，但每4点不得大于0.8A。当你的系统输出频率为每分钟 6 次以下时，应继电器输出，因其电路设计简单，抗干扰和带负载能力强 当频率为 10 次/min 以下时，既可采用继电器输出方式，也可采用PLC输出驱动达林顿三极管（5-10A），再驱动负载。

  英维思卡件TRICONEX 3511当PLC输出带感性负载，负载断电时会对PLC的输出造成浪涌电流的冲击，为此，对直流感性负载应在其旁边并接续流二极管，对交流感性负载应并接浪涌吸收电路，可有效保护 PLC 当两个物理量的输出在 PLC内部已进行软件互锁后，在 PLC的外部也应进行互锁，以加强系统的可靠性

The company specializes in importing PLC modules, programmable controllers, servo control systems, and DCS spare parts,

For example: ABB, AB, GE, Bently, FOXBORO MOTOROLA XYCOM HONEYWELL TRICONEX SCHNEIDER REXROTH YOKOGAWA, KUKA, OVATION, HIMA, etc.

The TRICONEX 3511 Invensys control system communication module for Invensys card parts can provide product quotes and information details. Please contact me

Precautions for output circuit design:

3.1. Selection of Output Method

(1) Relay output: The advantage is that different common points can carry different AC and DC loads, and the voltage can also be different, with a load current of up to 2A points; However, the relay output method is not suitable for high-frequency action loads, which is determined by the lifespan of the relay. (2) Thyristor output: with a load capacity of 0.2A/point, it can only carry AC loads and can adapt to high-frequency action, with a response time of 1ms. (3) Transistor output: The advantage is that it is suitable for high-frequency action, with a short response time, usually around 0.2ms. However, it can only carry DC5-30V loads, and the output load current is 0.5A/point, But every 4 points shall not exceed 0.8A. When the output frequency of your system is less than 6 times per minute, relay output should be used. Due to its simple circuit design, strong anti-interference and load carrying capacity, when the frequency is less than 10 times per minute, either relay output mode or PLC output can be used to drive the Darlington transistor (5-10A) and then drive the load.

When the PLC output carries an inductive load and the load is cut off, it will cause a surge current impact on the PLC output. Therefore, the DC inductive load should be placed next to it and connected to a continuous current diode. The AC inductive load should be connected to a surge absorption circuit in parallel, which can effectively protect the PLC. When two physical quantities of output have been software interlocked inside the PLC, they should also be interlocked outside the PLC to enhance system reliability

TRICONEX 3511 脉冲输入模块 工控备件模块库存

3700A 模拟量输入模块

3704E 模拟量输入模块

3604E 数字量输出模块

3614E 数字量输出模块

3615E 数字量输出模块

3624 数字量输出模块

3603B 数字量输出模块用的端子面板9251-210

3806E 模拟量输出模块用的端子面板9863-710

3501E 数字量输入模块 115VAC/VDC32pts 通用端子9561-

810 不通用端子9561-110 基本端子9551-110 9101-010

9141-010

3502E 数字量输入模块 48VAC/VDC32pts 通用端子9562-

810 基本端子9552-610 9101-010 9142-010

3503E 数字量输入模块 24VAC/VDC32pts 通用端子9563-

810 9563-910 基本端子9553-610 9572-610 BP9228-010

9143-010

3504E 数字量输入模块 24/48VDC 通用端子9566-81024V

9565-81048V 基本端子 9750-31024V 9750-41048V

BP229-010

3505E 数字量输入模块 24VDC 通用端子9563-810 9563-

910 基本端子9553-610 9572-610

3510 PI 20-20000 HZ 8pts 基本端子9753-110

3511 PI 20-20000 HZ 8pts 基本端子9753-110 9793-110

9794-110

3515 脉冲累加模块24VDC32pts 基本端子9753-110 9572-

610